Field applied, corrosion protection for pipe supports

Peel and Stick

DynaGard is an easy to install, corrosion protection system that isolates the pipe from its support. It consist of a rigid, composite shell, fitted with a corrosion resistant, adhesive liner. Unlike wear pads that must be welded or glued, it just takes a minute to peel off the protective release liner and stick the DynaGard on to the pipe.

Installation

• Raise pipe off support
• Clean and dry bottom of pipe
• Remove DynaGard release liner
• Center DynaGard over support
• Stick to pipe at 6 o’clock
• Pull firmly against pipe
• Lower pipe back on to support

Easy to Install

• Minimal surface preparation
• No mixing or set-up time
• No straps or hot work
• Installed in minutes

Eliminates Corrosion

• No moisture penetration
• No condensation cavities
• No crevice corrosion
• No metal to metal contact
• No interference with CP

+ top